Commercial Roofing Contractor in Irving, TX
Chasing one roof leak through three phone numbers is how a small problem turns expensive. Irving buildings get one local roofer for the whole flat and low-slope trade. Seal the seam. Roll the coating. Document the hail hit before it weathers away. Or tear off the membrane and lay a new one. Every option comes back in writing, one scope and one price, and nothing moves until you sign off.
Send the building details
Flat and low-slope commercial roofing in Irving, handled end to end.
Walk almost any commercial property in Irving and the roof up top is flat or gently sloped, which puts it in a different world from the pitched, shingled roof on a house. Instead of shingles shedding water downhill, one continuous membrane or a built-up asphalt system holds the whole deck watertight while interior drains carry the runoff away. When these roofs fail, they rarely fail out in the field. The trouble almost always shows up at a connection point: an opened seam, the flashing along a parapet, the boot around a rooftop HVAC curb, or a clogged drain that lets water pool.
Counterintuitive as it sounds, that is good news, since most leaks are a repair at the joint, not a new roof. Getting to that answer takes very little on your end. Fill out the short form, a local roofer who knows commercial membranes comes out to walk the surface, and you leave with a clear verdict, repair, coating, or full replacement, backed by one number in writing.
The flat and low-slope systems on Irving commercial roofs.
There is no universal best system; the right membrane for a given roof depends on how much slope it has, how it drains, how much rooftop equipment crowds it, the beating Dallas County hail delivers each spring, and how many more years you intend to own the building. A local roofer reads those factors, recommends a system to suit them, and puts the price on paper.
TPO
The white, hot-air-welded thermoplastic membrane you now see on most newer Irving flat roofs. Its reflective top pushes back Texas summer heat, and the welds fuse every sheet into a single unbroken skin.
EPDM
Black synthetic rubber, proven over decades on warehouse and other large low-slope roofs. Specify a thicker gauge and keep the seams tight, and it holds up for the long haul.
PVC
A welded membrane engineered to resist grease and chemical fumes. Where a kitchen exhaust vents cooking oils onto the roof, this is the sheet that survives it while weaker membranes degrade.
Modified bitumen
Reinforced asphalt applied in stacked, bonded plies. The added thickness resists punctures from constant foot traffic, so it fits compact roofs where rooftop units get serviced regularly.
Flat roof repair and replacement
When a low-slope roof gives out, the fix ranges from pinpointing a bad seam, flashing, or drain and patching it to spec, up to stripping the deck bare and laying a fresh system once the old one is beyond saving.
Roof coatings
A silicone or acrylic membrane brushed or sprayed on. Over a roof that is still dry and structurally sound, it renews the surface and adds years at a small slice of what a tear-off would run.
Not sure which of these is even on your roof? That gets settled during the free walk-through. A leaking flat roof on a house or a small storefront belongs under flat roof repair, while any damage a hailstorm left behind routes to storm and hail damage.
The full range a commercial roofer covers in Irving.
Everything a flat or low-slope roof might need, whether that is one weeping seam or a complete replacement.
- 01Leak and seam repair
- Finding the exact seam, flashing detail, pipe penetration, or drain where water is getting past the membrane, then repairing it with materials compatible with that membrane so the patch fuses and stays put.
- 02Replacement and re-roofing
- Installing a fresh membrane, TPO, EPDM, PVC, or modified bitumen, once the current roof is finished, and recommending a full tear-off up front whenever soaked insulation or two existing layers make a recover a bad idea.
- 03Coatings and restoration
- Rolling a silicone or acrylic coating onto a roof that checks out dry and solid, which reseals the top and extends its life while skipping the expense of a rip-and-replace.
- 04Storm and wind damage
- After a Dallas County storm, a roofer inspects the membrane for hail bruising and wind uplift, documents it with photos before the marks weather away, and puts a temporary hold on any active leak. These calls jump the queue, and same-week storm response is the norm.
- 05Inspections and upkeep
- Scheduled visits that clear the drains, look over every seam and flashing, and flag minor issues before they grow into leaks, timed to whatever cadence the building calls for.
It always begins the same place: a no-obligation walk of the roof and a scope in writing. When an insurance claim is part of the picture, how roof insurance claims work lays out the steps.
How a commercial job runs, start to finish.
Four steps, and the numbers are on paper the whole way.
Tell us about the building
Drop the address, the roof type if you know it, and a line on what is going wrong into the form. From there a local roofer who handles commercial work reaches out.
Get up on the roof
On site, the roofer pins down which membrane you have, works through the seams, flashings, and drains, and shoots photos of the real condition rather than whatever would pad an invoice.
Read the written quote
You receive the options, repair, coat, or replace, spelled out in plain terms with a price attached, all before a single tool comes out, and the schedule bends around your operating hours.
The roof gets finished
The membrane goes down or the repair goes in to manufacturer spec, the drains get tested to confirm they run clear, and the workmanship is backed in writing.
What Irving building owners ask about commercial roofs.
Plain answers on fixing versus replacing, storm claims, permits, and what it costs.
Q1Should I repair, coat, or replace my commercial roof?
Q2How do storm and hail claims work on a commercial roof?
Q3Will roof work shut my business down?
Q4Do I need a permit for commercial roof work in Irving?
Q5How much does commercial roofing cost in Irving?
Q6What should I check on any commercial roofer in Texas?
Find out where your Irving commercial roof really stands.
Send one short form and a local roofer who lives in flat and low-slope work comes out, evaluates your roof, walks you through repair, coating, or replacement, and leaves a written number behind. Free to ask, nothing owed, no pressure to book.