Brick ranch home with gray shingle roof shaded by mature trees

Irving roofersFree estimates · full-service & fast when a storm hits.

Gutter Repair and Installation in Irving, TX

A hard DFW downpour moves a lot of water off a roof in minutes, so a local roofer sizes seamless gutters to your roofline and repairs the runs that sag, leak, or took hail.

Price my gutter work

Gutter work is really roof-edge work

Gutter repair in Irving starts at the roof edge, not the ground. The gutter hangs off the fascia, tucks under the drip edge where the shingles end, and hands the water to downspouts that carry it clear of the slab. When any one of those is off, the roof sheds its water into the flower beds and the foundation instead. A local roofer reads the whole edge before quoting, so the number covers the real problem and not just the part you can see from the driveway.

For new work, seamless gutters are formed on site in one continuous length per side, which drops the every-few-feet joints where sectional gutters start to drip. For a repair, the fix follows the cause: a pulled hanger gets re-anchored, a flat run gets re-pitched, and soft eave wood gets handled before anything new goes back up. If the fascia or decking behind the gutter has failed, that crosses into roof repair, and your roofer will say so plainly.

Gutter topped by a clipped mesh guard next to gray asphalt shingles

Scope

What gutter service covers

New runs or a fix, the goal is the same: water off the roof and away from the house.

01Seamless gutters formed on site: One continuous length per side, rolled to the exact run at the house, which removes the joints where sectional gutters start leaking.
02Sized for a DFW downpour: Gutter width and the number of downspouts are matched to how much water each roof plane sheds, since an undersized run just overflows in the first hard storm.
03Repairs matched to the cause: A sagging run, a separated seam, a bad slope, and a pulled hanger each take a different fix, and your roofer names which one you have before pricing it.
04Tied into the roof edge: New gutters are hung to sit right under the drip edge, so water leaving the shingles drops into the run instead of behind it.

Not sure whether the run is the problem or the wood behind it? A quick roof inspection tells you which repair the edge actually needs before anything gets priced.

The standard

How gutter work goes

Measured and priced first, then rolled and hung at the house.

Measure and diagnose

A local roofer walks the roofline, checks the fascia, and works out whether you need a repair, a partial run, or full replacement. The estimate is free and it comes in writing.

Form and hang

New seamless runs are rolled at the house, pitched toward the downspouts, and hung with hidden hangers set into sound fascia, not tired wood.

Send the water clear

Downspouts and extensions are placed so the discharge lands past the foundation, and the finished runs get checked under flow where practical.

Signs your Irving gutters need attention

Spot one of these and it is time to have the edge looked at.

Water sheeting over the front lip in a steady rain instead of draining
A run sagging mid-span or pulling away from the fascia
Washed-out mulch, trenches, or splashback along the foundation under the eaves
Peeling paint or soft, dark wood on the fascia behind the gutter
Dents and dimples along the top lip and downspouts after a hailstorm

Hail hard enough to dent a gutter almost always bruised the shingles in the same cell, so after a storm have the roof and the gutters checked together.

On a roof here

What Irving weather asks of a gutter

Dallas County storms do not arrive gently. The NOAA record for the county logs 23 hail days and 96 hail reports across a recent four-year window, with hail measured to 4.00 inches and winds to 96 mph. Rain that rides the same cells can fill an undersized gutter faster than it drains, and hail that large dents the top lip and the downspouts even when the run still carries water. Irving's housing stock adds a second factor. With many of the older homes built back in the 1970s, a lot of local eaves are on their second or third gutter, hung from fascia that has weathered decades of Texas sun and rain. That older wood is why a sagging run here is so often a fascia problem first, and why the board gets checked before a new gutter goes up.

01Built for downpour volume: Sizing the run and the downspouts to the roof plane keeps a DFW cloudburst inside the gutter instead of over the edge.
02Hail dents are evidence: Dented lips and downspouts help date a storm, which matters if the shingles took the same large hail.
03The fascia carries the load: Decades of Irving sun age eave wood, so a drooping gutter often points to a board that needs attention first.

Replacing the roof anyway? New gutters and the drip edge get sequenced together on the same job, so it is worth pricing them as part of a roof replacement rather than a second trip later.

Gutter questions

What Irving homeowners ask before they call about gutters.

Q1Do you repair gutters, or only install new ones?

Both, though most gutters can be repaired rather than replaced. A lot of Irving gutter problems are single-run fixes: a re-pitched span, new hangers, a resealed corner, or a patched seam. Your roofer walks the edge, tells you honestly which side of the repair-or-replace line you are on, and the written estimate prices only what the run needs.

Q2What size gutters do Irving homes need?

Most Irving homes are well served by 5-inch K-style gutters, but steeper or larger roof planes that shed a lot of water in a DFW downpour often call for 6-inch runs and an extra downspout. The right size comes from measuring the roof planes, not from a one-size quote, so a local roofer matches the run to the water it actually has to carry.

Q3Are seamless gutters worth it over sectional?

For most homes, yes. Seamless gutters are formed in one piece at the house, so the only joints are at corners and downspouts, while sectional gutters add a seam every few feet and every seam is a future drip. The price gap is usually modest and the run lasts longer for it.

Q4Do gutter guards make sense in Irving?

It depends on your trees. If you have live oaks or other heavy shedders dropping onto the roof, guards cut the cleaning and keep the runs draining through storm season. If the roof sits clear of trees, they are usually not worth the added cost, so ask for the straight read when the roofline gets measured, not a package pitch.

Q5My gutters got dented by hail. Is that worth a claim?

On their own, dented gutters are often treated as cosmetic. But hail hard enough to dent metal, and Dallas County has recorded hail to 4 inches, usually bruised the shingles in the same cell, and that is the part worth documenting. A dated, photographed roof check shows what the storm actually did, and the insurance claims guide explains how gutters fit into a claim.

Q6Should I replace the gutters when the roof is replaced?

Often, if the runs are already old. The roofer is working the roof edge anyway, so the drip edge and new gutters get sequenced together and the whole job means one disruption instead of two. Newer gutters can stay and get protected during the tear-off, which is standard practice.

Irving roofers

Get your Irving gutters measured and priced

Tell us what the runs are doing, whether that is sheeting over the edge, sagging off the fascia, or dented from the last storm, and a local roofer measures the roofline and hands you one written number for exactly what the edge needs.